Re: [CAD_CAM_EDM_DRO] Re: Converting a rotary table

If it is anything like the one I converted, have a good scrape round
inside the casting while you have it apart. I got about 2 tablespoons of
casting sand out of mine.

Les


cutsgems wrote:

>There are two setscrews on the side of the table. One allows you to
>rotate the worm assy and adjust the backlash or disengage the worm.
>the other retains the entire worm assy. Loosen both setscrews and the
>worm assy. will pull free of the table. On the bottom there is a
>large ring with a compression lock scheme. You loosen the locking
>Screw then remove the ring and the table will come out of the base
>casting.
>
>My replacement table should be here today or tomorrow and I'll have
>to disassemble it for cleaning. I'll photo document the proceedure
>and post it to a website along with my mounting setup.
>
>--C
>
>

--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.9.6/59 - Release Date: 27/07/2005