Re: [CAD_CAM_EDM_DRO] BDI-4.20 Software Installation
Posted by
Tom Hubin
on 2005-08-04 12:16:11 UTC
nwlinfo wrote:
Hello Mark,
A SCSI drive can be a problem with running EMC. I installed EMC and
TurboCnc on a machine with a SCSI hard drive. Both installed and ran
without complaint. However, machining was very erratic. Lots of pauses
causing stalling probably due to unsuppressable hardware interrupts.
The TurboCnc authors warn not to use SCSI hard drives. I think that the
EMC authors also issue the same warning.
SCSI does not account for your installation problems but you might be
beating a dead horse if it won't run ok after you get a successful
install.
You might also get some helpful tips on the EMC users group list. I
think you find your way to that starting at http://www.linux.org .
Tom Hubin
>*********************
> Greetings, I am having difficulties with the installation process
> for EMC/Debian combo (BDI-4.20) on a 5 yr old P3 w/ 512MB ram.
> The computer has an Adaptec AIC-7899 SCSI controller.
Hello Mark,
A SCSI drive can be a problem with running EMC. I installed EMC and
TurboCnc on a machine with a SCSI hard drive. Both installed and ran
without complaint. However, machining was very erratic. Lots of pauses
causing stalling probably due to unsuppressable hardware interrupts.
The TurboCnc authors warn not to use SCSI hard drives. I think that the
EMC authors also issue the same warning.
SCSI does not account for your installation problems but you might be
beating a dead horse if it won't run ok after you get a successful
install.
You might also get some helpful tips on the EMC users group list. I
think you find your way to that starting at http://www.linux.org .
Tom Hubin
Discussion Thread
nwlinfo
2005-08-03 14:21:42 UTC
BDI-4.20 Software Installation
Alan Marconett
2005-08-03 14:54:03 UTC
[Spam] RE: [CAD_CAM_EDM_DRO] BDI-4.20 Software Installation
Max
2005-08-03 15:38:45 UTC
Re: [CAD_CAM_EDM_DRO] BDI-4.20 Software Installation
Jon Elson
2005-08-03 17:16:19 UTC
Re: [CAD_CAM_EDM_DRO] BDI-4.20 Software Installation
David A. Frantz
2005-08-03 20:30:37 UTC
Re: [CAD_CAM_EDM_DRO] BDI-4.20 Software Installation
Tom Hubin
2005-08-04 12:16:11 UTC
Re: [CAD_CAM_EDM_DRO] BDI-4.20 Software Installation
North Western Limited
2005-08-05 06:57:23 UTC
BDI-4.20 Software Installation (still having problems)