Re: [CAD_CAM_EDM_DRO] Re: Manual Control

If the servos run away like that it means that the drives aren't seeing
the encoders correctly. The motor encoders must go to the encoder
inputs. If you want to run the motors with an mpg, connect the mpg to
the step/direction impouts.

Les

roboticscnc wrote:

>I connected the encoders as explained but when I switch the power on
>the servos just run at maximum speed without the drivers showing a
>position error. Maybe there is something missing in the circuit. I'm
>trying to finish my lathe retrofit during this week before I have to
>go back to work so I don't want to order anything from overseas. Is
>there a simple way to get the required signal from the encoders ?
>Thanks, Glen.
>
>
>