Re: [CAD_CAM_EDM_DRO] emc problems

Linux that works is great, Linux that goes on strike #""&$$#(UT G¡==)>X*
Since May I am not able to throw windows away, because neither me nor my
professor from tecnical high school were able to get it running.
It sounds like you need to set up right the perifery. And if your EMC
set up allready and you took off the interface cards and drivers, then
the machine expects them and cannot find them. First thing run safe mode
and check the settings.
Later get a specialist.
That is why the "free" software may sometimes become more expensive then
the payed licence software.


----- Mensaje Original -----
De: Ray Webster <tazman03@...>
Fecha: Sábado, Diciembre 31, 2005 0:43 am
Asunto: [CAD_CAM_EDM_DRO] emc problems

> Having what seems to be a driver issue here. My buddy installed
> a
> version of Linux on this machine I'm going to use with a homebrew
> gantry mill. Every time I start EMC, the computer locks up hard
> after
> a couple minutes. The Linux version screen says it's KDE ver.
> 3.3.2,
> Linux realease 2.6.12.6-magma. There are a couple versions of EMC
> on
> here (a Sherline version and the generic install) but either of
> them
> will lock up. Have to power down at the supply to break it.
> Any ideas anyone? I have switched monitor, keyboard and mouse
> to no
> effect. Installer said it ran ok on his bench, doesn't on mine.
> It's
> not hooked up to the mill yet.
> Thanks,
> Keith
>
>
>
>