Re: RE: [CAD_CAM_EDM_DRO] emc problems

Keith, as said I am not any gurru here. as periphery I mean interface
cards, driver, dro scales with their boards, input/output, relay cards,
printer. modem...........
I remember some time ago Paul Corner had tough times when he first
brought out his BDI-EMC because not all Linuz versions would run smoth.
You might check your versions and dig into the post archives here.
I for my person with my problems with suse 10.0 simply wait until my
Profesor will be back from vacations.
Sven

----- Mensaje Original -----
De: tazman03 <tazman03@...>
Fecha: Sábado, Diciembre 31, 2005 10:58 am
Asunto: RE: [CAD_CAM_EDM_DRO] emc problems

> We've never had board or motors connected to this thing (yet); just
> running EMC in simulation on the PC. What do you mean by 'periphery'?
> What settings should I check I safe mode?
> I skimmed the FAQ over at the EMC site with not much luck.
> Checked a
> couple other trouble-shooting files over there as well with equal
> results.
> My 'expert' is 350km away right now and cannot get here to
> help. On
> our own, more or less.
> Thanks,
>
> Keith
>
>
>
> -----Original Message-----