Re: [CAD_CAM_EDM_DRO] When[emc]

One small problem, everyone might have different hardware
configurations, such as Athlon instead of Celeron, 486 instead of PIII,
and so on. Doesn't take much to lose system stabilities.

Derek B wrote:

> I agree with you 100%!
> I have been talking with Tim Goldstein about burning Cd-roms. Tim
> seems
> to have worked out all the bugs and has a smooth running program. What
> I
> want to do is copy his complete setup off of his computer, with all
> the
> patches installed etc. and burn this to cd-rom.
>
> I am willing to burn the 50 cd-roms I have, for the list, for just the
>
> shipping cost of approximately $2.50 each. I might be wrong but all
> you
> would have to do is partition a drive and copy the cd-rom to the
> partition. It would be like making a duplicate of the original hard
> drive, which has the complete operating system. Possibly it might take
> 2
> cd-roms.
> Let me know if any one is interested, feedback is important.
> Derek B.
>
> wanliker@... wrote:
> >
> > My questions today are:
> >
> > 1. When is it going to get easy to implement LINUX/EMC, without
> being a
> > programmer to get it running? How about it programmers, make it as
> easy as
> > Windoz. Put disc in, and run in xx minutes.
> >
> > bill
> >
> >
> ------------------------------------------------------------------------
>
> > Was the salesman clueless? Productopia has the answers.
> > http://click.egroups.com/1/4633/4/_/423600/_/961788848/
> >
> ------------------------------------------------------------------------
>
> >
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
> >
> > Addresses:
> > Post message: CAD_CAM_EDM_DRO@egroups.com
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> > List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> > Moderator: jmelson@... [Moderator]
> > URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> > FAQ: http://www.ktmarketing.com/faq.html
> > bill,
> > List Manager
> -----------------------------------------------------------------------
>
> -----------------------------------------------------------------------
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

[Non-text portions of this message have been removed]