Re: [CAD_CAM_EDM_DRO] Re: CNC webpage hijacking, may concern you

Hi Guys:

Someone pointed out that I too am cross linked to some of these pages. But
I suspect no
harm was intended, getting web pages setup and functional when your first
starting out is hard,
many misunderstandings about how they are used, and though I know some get
upset when things like
this occur, I too have inadvertantly been guilty of such things throguh
simple ignorance of the things
it takes to run a website. (or two. :-) ), luckily, Ive had some real great
support from group memebers to help me
through it. I suspect Martin only means to get as much information out there
as possible...usually a good thing..

Hopefully, the ill effects can be taken care of and if he's a responsible
person, I sure he'll take the links away..

(I have so many links on the ArtSoft site that I sometimes worry Ive screwed
someone up as well, though mine are usually
done at request..)

(Dont know Martin,just an opinion..)

Thanks,
Art
www.artofcnc.ca

Videos And Support Forums http://www.machsupport.com
Users Map: http://www.frappr.com/machsupport

----- Original Message -----
From: "Graham Stabler" <eexgs@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, February 03, 2006 12:40 PM
Subject: [CAD_CAM_EDM_DRO] Re: CNC webpage hijacking, may concern you


> Steve is correct that the page seen is still mine although in a frame
> however this is still a very bad way to link to other peoples sites,
> when it comes to bookmarking especially. I had thought it was a
> direct copy and that shows just how misleading it can be considering
> it is my page.
>