Re: [CAD_CAM_EDM_DRO] Re: Parts source Needed

Graham Stabler wrote:

>>I just wire all mine direct. 2 hp servos with 2.5:1 reduction = 5 hp
>>
>>
>at the lead screw. The last thing I need is a runaway.
>
>
>>
>> Ron
>>
>>
>
>
>Surely if you loose a connection the last thing it will be doing is
>running away unless it is an encoder connection perhaps.
>
>
>

Yes, exactly! If any one of the four wires in the typical encoder
setup goes open, the drive will not be able to sense motion greater
than one encoder count, and the drive will run away.

Jon