Re: How to cut card board about 1mm thick using router table.
Posted by
vrsculptor
on 2006-04-15 12:08:41 UTC
Mach3 can drive a tangential knife which is much better than a vinyl
drag knife. I think the thickness that it could cut is dependent on
your hardware/knife.
Roger
drag knife. I think the thickness that it could cut is dependent on
your hardware/knife.
Roger
> Is there any company sell the hardware and software to add into the
> head. I don't mind to change the controller if there is a solution to
> make the thing easier for operation.
> Any suggestion welcome.
> can contact me direct at output123@...
Discussion Thread
output_123
2006-04-14 16:45:48 UTC
How to cut card board about 1mm thick using router table.
Jim Fleig - CNC Services
2006-04-14 18:20:01 UTC
Re: [CAD_CAM_EDM_DRO] How to cut card board about 1mm thick using router table.
output_123
2006-04-14 18:44:07 UTC
Re: How to cut card board about 1mm thick using router table.
vrsculptor
2006-04-15 12:08:41 UTC
Re: How to cut card board about 1mm thick using router table.
output_123
2006-04-16 19:47:06 UTC
Re: How to cut card board about 1mm thick using router table.
vrsculptor
2006-04-16 20:19:50 UTC
Re: How to cut card board about 1mm thick using router table.
output_123
2006-04-17 07:53:21 UTC
Re: How to cut card board about 1mm thick using router table.
vrsculptor
2006-04-17 09:06:16 UTC
Re: How to cut card board about 1mm thick using router table.