Re: How to cut card board about 1mm thick using router table.

No, I don't have a link but you can find some information in the manual
<http://www.machsupport.com/documentation/M3M1_84-A1Rel.pdf>. I don't
use this feature but I think Mach3 treats the knife as a separate axis
much like a spindle. You would have to refit your machine as Mach3
needs to drive all axis for this feature to work. Mach3 can drive up to
6 axis.

> Do you have any link or pointer where I can find tangential life for
> mach3 to drive it?
> Thanks.