Re: How to cut card board about 1mm thick using router table.

Do you have any link or pointer where I can find tangential life for
mach3 to drive it?
Thanks.
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "vrsculptor" <vrsculptor@...>
wrote:

>
> Mach3 can drive a tangential knife which is much better than a vinyl
> drag knife. I think the thickness that it could cut is dependent on
> your hardware/knife.
>
> Roger
>
> > Is there any company sell the hardware and software to add into the
> > head. I don't mind to change the controller if there is a solution to
> > make the thing easier for operation.
> > Any suggestion welcome.
> > can contact me direct at output123@
>