Re: [CAD_CAM_EDM_DRO] Servo/Stepper on a Surface Grinder

In a message dated 4/26/2006 4:15:15 PM Mountain Daylight Time,
johnd@... writes:

So the only thing that it can't do directly is move the grinder over.
Alternatively with minor software changes, perhaps the X can move the table
under the grinder after each group of passes and you manually adjust the
grinding depth by hand.



I would think you could program it just like you would milling grooves on
the top of a plate in a mill. You would be inputting the size, and feeds in
the G codes. ETC. Each groove would be the horizontal advance of the table.
bill


[Non-text portions of this message have been removed]