RE: [CAD_CAM_EDM_DRO] Servo/Stepper on a Surface Grinder

Hi

This sounds like a similar task to threading on the lathe. Check out the
ELS list for a possible solution.

Alan KM6VV

>
> In a message dated 4/26/2006 4:15:15 PM Mountain Daylight Time,
> johnd@... writes:
>
> So the only thing that it can't do directly is move the grinder over.
> Alternatively with minor software changes, perhaps the X can move the
> table
> under the grinder after each group of passes and you manually adjust the
> grinding depth by hand.
>
>
>
> I would think you could program it just like you would milling grooves on
> the top of a plate in a mill. You would be inputting the size, and feeds
> in
> the G codes. ETC. Each groove would be the horizontal advance of the
> table.
> bill