Re: Gecko connection to unipolar stepper??

COMMON means "shared". What would you call it on a G210/G212 where
COMMON can be jumper-configured as either +5V or GND?

Mariss


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "ballendo" <ballendo@...>
wrote:

>
> Mariss,
>
> I have ultimate respect for you as a product designer, but...
>
> Calling that term 10 "common" was/is a mistake?<G>
>
> Sure, I understand what you were thinking at the time--you've

posted

> before the rationale--but it sure seems to confuse a whole bunch of
> folks that visit these forums...
>
> Ballendo
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Mariss Freimanis"
> <mariss92705@> wrote:
> >
> > So far so good; that is correct. Make sure the two unused wires
> are
> > insulated and not touching each other or anything else. Use a 33K
> > current set resistor, connect 5VDC from your PC to COMMON (term
> 10),
> > STEP and DIRECTION and you're good to go.
> >
> > Mariss
>