Re: Camera software

Dennis,

Depends upon what you mean by "accurate" and "measurement";

Check out ScanZ and Dan Mauch's low cost 3d digitiser...

Are these along the lines<pun intended<G> of what you mean?

Ballendo

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Dennis Schmitz"
<denschmitz@...> wrote:

>
> If someone had software that would allow accurate measurement of parts
> by use of camera input only, and perhaps a light, would there be a
> market for it?
>
> If it's been done already, I'd be feeling two months' effort level
> gratitude if you'd kindly point me to it...
>