CAD CAM EDM DRO - Yahoo Group Archive

Re: Camera software

Posted by Chris Horne
on 2006-07-31 14:21:00 UTC
Nope,

but I would be wary of lenses, unless you have very expensive optics,
you will need to build in compensation for distortion.

Chris

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Dennis Schmitz"
<denschmitz@...> wrote:
>
> If someone had software that would allow accurate measurement of parts
> by use of camera input only, and perhaps a light, would there be a
> market for it?
>
> If it's been done already, I'd be feeling two months' effort level
> gratitude if you'd kindly point me to it...
>

Discussion Thread

Dennis Schmitz 2006-07-31 13:35:59 UTC Camera software Chris Horne 2006-07-31 14:21:00 UTC Re: Camera software ballendo 2006-07-31 23:25:48 UTC Re: Camera software George Taylor, IV 2006-08-01 00:12:06 UTC RE: [CAD_CAM_EDM_DRO] Camera software th_carel 2006-08-01 01:17:36 UTC Re: [CAD_CAM_EDM_DRO] Camera software Elliot Burke 2006-08-01 06:48:02 UTC Re: Camera software Dennis Schmitz 2006-08-02 12:17:41 UTC Re: [CAD_CAM_EDM_DRO] Re: Camera software wanliker@a... 2006-08-02 13:11:26 UTC Camera software Dennis Schmitz 2006-08-02 14:08:27 UTC Re: Camera software Elliot Burke 2006-08-02 17:37:19 UTC Re: Camera software Graham Stabler 2006-08-03 02:24:58 UTC Re: Camera software Dennis Schmitz 2006-08-03 04:05:20 UTC Re: [CAD_CAM_EDM_DRO] Re: Camera software Graham Stabler 2006-08-03 05:20:55 UTC Re: Camera software Dennis Schmitz 2006-08-03 06:40:25 UTC Re: Camera software Graham Stabler 2006-08-03 08:07:04 UTC Re: Camera software wthomas@g... 2006-08-03 21:28:46 UTC W.E.T.Re: [CAD_CAM_EDM_DRO] Edge Finder Graham Stabler 2006-08-04 03:01:59 UTC W.E.T.Re: [CAD_CAM_EDM_DRO] Edge Finder