Re: bridgeport boss servo

Ordered the Rutex R9990H and connector this morning. Just have to
wait for all the parts to come in. Thanks to everybody, especially
Les, for all your help. I'm sure you'll hear from me again before
its all installed.

Thanks again
Nathan



--- In CAD_CAM_EDM_DRO@yahoogroups.com, Les Newell <lesnewell@...>
wrote:

>
> Actually looking at the picture it looks like the differential

version

> is purely a RJ45 to screw terminal adapter. In that case you may

as well

> wire the cable straight into the encoder. The single ended version

does

> appear to have some circuitry on it. Have a look at this pic
> <http://www.rutex.com/pic/2010.jpg>. The RJ45 is next to the screw

terminal.

>
> As you are using a DeskCNC board I wouldn't recommend using the

R2000

> series drives. To set the drives up you will have to make a

parallel

> port adapter so you can run their tuning software. Note if you do

buy a

> R990h drive, make sure you also order the screw terminal plug if

you

> aren't using their motherboard.
>
> Les
>
>