Re: [CAD_CAM_EDM_DRO] Re: Z-Axis problem - Not Enough Torque?

At 11:11 09/11/2006, you wrote:

>1. I noticed a lot of advise from others regarding counterweighing the
>Z-axis head as well. Maybe I am missing something here. Is it a must or a
>better solution to do a Z-axis by counterweighing? Kindly look at my earlier
>post reply to "Brian Worth" regarding this.

Form your pics (posted on one of the other groups) counterweighting
is absolutely not any part of the answer, as you are driving the
quill, not the whole of the head. Also, as some round column mills
have a tendency to lose X-Y position as you crank the head up and
down, you've probably gone the right way here.

>2. Timing belt/pulley reduction may be the first thing I will try.

Its pretty obvious (to me, at least!) from your pics that this is the
right way to go (or use a finer pitch leadscrew.

One point to watch - in your setup the bottom end of the screw is
completely exposed and will attract swarf/dust from milling
operations. Unless you want to disassemble/clean the screw and nut on
a regular basis you are going to need some kind of cover over the screw.

Regards,
Tony