CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] cheap edm tap buster?

on 2007-03-11 13:42:17 UTC
On Sat, 10 Mar 2007 23:25:50 -0600, you wrote:


>Because this thing has voltage on the electrode essentially all the
>time, it needs very
>clean water or it will foam like crazy with electrolysis. I couldn't
>get clean enough
>water, but then I didn't try real hard, either.

Hi Jon - I've an old commercial Watton Electronics "Arc-out" tap
buster that uses a vibrator coil (solenoid) to peck the electrode up and
down. It only outputs 12-15V DC and runs fine using plain old tap water,
as per the manual.

It more than paid for itself on the first commercial job removing a
broken stud out of a cylinder block for a local garage. Beauty of it is,
it's portable and can be set up almost anywhere. It's done quite a bit
of work once word got around <G>.

Steve Blackmore
--

Discussion Thread

electromodeler 2007-03-09 11:33:49 UTC cheap edm tap buster? Andy Wander 2007-03-09 12:12:13 UTC RE: [CAD_CAM_EDM_DRO] cheap edm tap buster? Jon Elson 2007-03-09 19:29:48 UTC Re: [CAD_CAM_EDM_DRO] cheap edm tap buster? turbulatordude 2007-03-09 21:03:12 UTC Re: cheap edm tap buster? Brian Worth 2007-03-10 00:03:36 UTC Re: [CAD_CAM_EDM_DRO] cheap edm tap buster? Mark Vaughan 2007-03-10 10:01:31 UTC RE: [CAD_CAM_EDM_DRO] cheap edm tap buster? Jon Elson 2007-03-10 21:29:17 UTC Re: [CAD_CAM_EDM_DRO] cheap edm tap buster? Mark Vaughan 2007-03-11 00:57:59 UTC RE: [CAD_CAM_EDM_DRO] cheap edm tap buster? Paul Kelly 2007-03-11 01:22:15 UTC RE: [CAD_CAM_EDM_DRO] cheap edm tap buster? caudlet 2007-03-11 09:31:18 UTC Re: cheap edm tap buster? Steve Blackmore 2007-03-11 13:42:17 UTC Re: [CAD_CAM_EDM_DRO] cheap edm tap buster? turbulatordude 2007-03-11 16:39:16 UTC Re: cheap edm tap buster? Steve Blackmore 2007-03-11 18:36:10 UTC Re: [CAD_CAM_EDM_DRO] Re: cheap edm tap buster? turbulatordude 2007-03-11 18:54:03 UTC Re: cheap edm tap buster? Jon Elson 2007-03-11 20:50:11 UTC Re: [CAD_CAM_EDM_DRO] cheap edm tap buster? Mark Vaughan 2007-03-11 22:21:12 UTC RE: [CAD_CAM_EDM_DRO] cheap edm tap buster? turbulatordude 2007-03-12 05:00:02 UTC Re: cheap edm tap buster? Jon Elson 2007-03-12 09:31:22 UTC Re: [CAD_CAM_EDM_DRO] Re: cheap edm tap buster?