Re: [CAD_CAM_EDM_DRO] Servo Mill drill video

Dan Mauch wrote:

> http://video.google.com/videoplay?docid=7735093752200071391
>
> I thought some of you would like to see Mach3 running my mill drill at 263 IPM.
> The motors are ID33005 7.5 lb in with 250 lines encoders and G320. Belt drive with 2.12 to ratio connected to a 5 TPI ballscrew.
> I don't recommend running it that fast but is does show that you can do when you have some time to play with the stuff you make.

Dan

Quite impressive, ought to remove those handles though ;)

Is there any reason the acceleration is a bit on the soft side? I'd
have though you could of been a little more aggressive with 250cpr encoders.

Wayne....

--
---------------------------------------------------------------------------
Wayne M Weedon Email: wayne@...
Fdos Design Poole UK
Tel +44-1202-677025 Fax +44-1202-770515 Mobile: 07774 439915

Specialists in small batch & Production Mechanical/Electrical Engineering
---------------------------------------------------------------------------