Re: [CAD_CAM_EDM_DRO] Servo Mill drill video

I have a bunch of AC servos and drives (Yaskawa sp?, and Panasonic). But I
assumed they wouln'd work with Mach. I'll probably sell the drives on Ebay
but the servos looks too good to part with. I just need to find a way to
integrate them.

Any suggestions?

Doug

On 4/23/07, Wayne Weedon <wayne@...> wrote:
>
> Doug M wrote:
> > Harko (and anybody else),
> >
> > Is anybody out there running AC servos & Mach?
>
> Not yet but I intend to very soon.
>
> >
> > If so, what controller are you using and/or recommend?
>
> By controller do you mean drive? Quite often these days AC setups
> consist of closely matched drives and motors from the same manufacturer.
> It's not compulsory but probably saves a lot of hassle.
>
> Unless you have something like a Galil card for mach you are looking for
> Digital drives which run in position mode with clock and direction
> inputs. There's a whole load of them on the market now. Prices vary
> greatly ;)
>
> Wayne....
>
> --
> ----------------------------------------------------------
> Wayne M Weedon Email: wayne@... <wayne%40fdos-design.com>
> Fdos Design Poole UK
> Tel +44-1202-677025 Fax +44-1202-770515 Mobile: 07774 439915
>
> Specialists in small batch & Production Mechanical/Electrical Engineering
> ----------------------------------------------------------
>
>


[Non-text portions of this message have been removed]