Re: [CAD_CAM_EDM_DRO] Fanuc 3m help
Posted by
Harko Schwartz
on 2007-05-22 11:48:56 UTC
They will check the board out for 250
Harko
Harko
On 5/22/07, rocketscientistnate <rocketscientistnate@...> wrote:
>
> I just bought a Yuasa CNC mill off of ebay, and I need a little help
> getting it going. It is a 1981 model and has a Fanuc 3M control. I
> keep getting an error that means the Z encoder cable is disconnected,
> and following the troubleshooting guide in the manual (swapping cables
> and such) I've concluded the mainboard is bad. Does anybody know where
> I can get this repaired at a reasonable price (less than $1000)? Fanuc
> says it has a flat rate for repair on this board, I'm not sure how they
> do that, but was $2260. WOW! Anyway, I'd really like to get this thing
> going.
> Thanks
> Nathan Clymer
>
>
>
[Non-text portions of this message have been removed]
Discussion Thread
rocketscientistnate
2007-05-22 10:38:14 UTC
Fanuc 3m help
Andrey Lipavsky
2007-05-22 11:08:14 UTC
RE: [CAD_CAM_EDM_DRO] Fanuc 3m help
Clarence -Will- Silvers
2007-05-22 11:26:23 UTC
RE: [CAD_CAM_EDM_DRO] Fanuc 3m help
Mark Vaughan
2007-05-22 11:36:21 UTC
RE: [CAD_CAM_EDM_DRO] Fanuc 3m help
Harko Schwartz
2007-05-22 11:48:56 UTC
Re: [CAD_CAM_EDM_DRO] Fanuc 3m help
afogassa
2007-05-22 13:47:55 UTC
Re: Fanuc 3m help
Vince Endter
2007-05-22 19:27:35 UTC
Re: Fanuc 3m help
Jon Elson
2007-05-22 21:01:55 UTC
Re: [CAD_CAM_EDM_DRO] Fanuc 3m help
Mark
2007-05-23 08:38:13 UTC
RE: [CAD_CAM_EDM_DRO] Fanuc 3m help