Re: Fanuc 3m help
Posted by
Vince Endter
on 2007-05-22 19:27:35 UTC
I don't know anything about a Fanuc 3m, but I just got done
converting a 1987 CNC knee mill from the original Allen Bradley
control to Mach 3. The total cost is under $800 and that does not
count the $300 I sold the Allen Bradley for.
If the drives are good, you can use a Pixie 100 to convert from step
and direction to +-10V. You can read about the conversion here:
http://www.cnczone.com/forums/showthread.php?t=31601
I was able to rapid at 125 IPM with the AB control, but I can now
move at 275 IPM with Mach 3.
Vince
converting a 1987 CNC knee mill from the original Allen Bradley
control to Mach 3. The total cost is under $800 and that does not
count the $300 I sold the Allen Bradley for.
If the drives are good, you can use a Pixie 100 to convert from step
and direction to +-10V. You can read about the conversion here:
http://www.cnczone.com/forums/showthread.php?t=31601
I was able to rapid at 125 IPM with the AB control, but I can now
move at 275 IPM with Mach 3.
Vince
>help
> I just bought a Yuasa CNC mill off of ebay, and I need a little
> getting it going. It is a 1981 model and has a Fanuc 3M control.I
> keep getting an error that means the Z encoder cable isdisconnected,
> and following the troubleshooting guide in the manual (swappingcables
> and such) I've concluded the mainboard is bad. Does anybody knowwhere
> I can get this repaired at a reasonable price (less than $1000)?Fanuc
> says it has a flat rate for repair on this board, I'm not sure howthey
> do that, but was $2260. WOW! Anyway, I'd really like to get thisthing
> going.
> Thanks
> Nathan Clymer
>
Discussion Thread
rocketscientistnate
2007-05-22 10:38:14 UTC
Fanuc 3m help
Andrey Lipavsky
2007-05-22 11:08:14 UTC
RE: [CAD_CAM_EDM_DRO] Fanuc 3m help
Clarence -Will- Silvers
2007-05-22 11:26:23 UTC
RE: [CAD_CAM_EDM_DRO] Fanuc 3m help
Mark Vaughan
2007-05-22 11:36:21 UTC
RE: [CAD_CAM_EDM_DRO] Fanuc 3m help
Harko Schwartz
2007-05-22 11:48:56 UTC
Re: [CAD_CAM_EDM_DRO] Fanuc 3m help
afogassa
2007-05-22 13:47:55 UTC
Re: Fanuc 3m help
Vince Endter
2007-05-22 19:27:35 UTC
Re: Fanuc 3m help
Jon Elson
2007-05-22 21:01:55 UTC
Re: [CAD_CAM_EDM_DRO] Fanuc 3m help
Mark
2007-05-23 08:38:13 UTC
RE: [CAD_CAM_EDM_DRO] Fanuc 3m help