CAD CAM EDM DRO - Yahoo Group Archive

Re: Fanuc 3m help

Posted by afogassa
on 2007-05-22 13:47:55 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "rocketscientistnate"
<rocketscientistnate@...> wrote:
>
> I just bought a Yuasa CNC mill off of ebay, and I need a little
help
> getting it going. It is a 1981 model and has a Fanuc 3M control.
I
> keep getting an error that means the Z encoder cable is
disconnected,
> and following the troubleshooting guide in the manual (swapping
cables
> and such) I've concluded the mainboard is bad. Does anybody know
where
> I can get this repaired at a reasonable price (less than $1000)?
Fanuc
> says it has a flat rate for repair on this board, I'm not sure how
they
> do that, but was $2260. WOW! Anyway, I'd really like to get this
thing
> going.
> Thanks
> Nathan Clymer
>

take a look at encoder cable, sometimes it breakes very close to the
pins, sometimes the pins itself gets oxidized.

Discussion Thread

rocketscientistnate 2007-05-22 10:38:14 UTC Fanuc 3m help Andrey Lipavsky 2007-05-22 11:08:14 UTC RE: [CAD_CAM_EDM_DRO] Fanuc 3m help Clarence -Will- Silvers 2007-05-22 11:26:23 UTC RE: [CAD_CAM_EDM_DRO] Fanuc 3m help Mark Vaughan 2007-05-22 11:36:21 UTC RE: [CAD_CAM_EDM_DRO] Fanuc 3m help Harko Schwartz 2007-05-22 11:48:56 UTC Re: [CAD_CAM_EDM_DRO] Fanuc 3m help afogassa 2007-05-22 13:47:55 UTC Re: Fanuc 3m help Vince Endter 2007-05-22 19:27:35 UTC Re: Fanuc 3m help Jon Elson 2007-05-22 21:01:55 UTC Re: [CAD_CAM_EDM_DRO] Fanuc 3m help Mark 2007-05-23 08:38:13 UTC RE: [CAD_CAM_EDM_DRO] Fanuc 3m help