RE: [CAD_CAM_EDM_DRO] Re: Big servo motors drive recommendations

Sorry Steve.

I normally try to leave the previous message or part of it so one knows what
the response was to.



But I do regularly forget to clip the rest. Please feel free to tell me off
when I do this, it is needed.

I get into the reply, then by the time I get to the end, wife and kids are
moaning so send gets clicked, as I realise it’s not complete.

I also much prefer your two liner, I tend to waffle too much, but don’t like
long posts they are too complex to follow, and I’m the guilty one here.



As to EMC2, I have spent a long time getting all the rest of the machine
configured to work with Mach, I don’t really want to get into another
package, I also have a massive array of programs prewritten for mach.

I have friends at University, research colleagues that use linux and some of
them EMC a lot, their initial presentation is that it’s brilliantly stable,
never falls over unlike windows, just what you want to hear, then you get to
hear about the inefficiencies, the bugs etc etc., and you really wonder
whether it is just having to learn something else full of bugs. I know mach
and I like it.



Regs Mark



Dr. Mark Vaughan Ph'D. B.Eng. M0VAU

Managing Director

Vaughan Industries Ltd, reg in UK no 2561068

Water Care Technology Ltd, reg in UK no 4129351

Addr Unit3, Sydney House, Blackwater, Truro, Cornwall, TR4 8HH, UK.
Phone/Fax 44 1872 561288

RSGB DRM111(Cornwall)

_____

From: CAD_CAM_EDM_DRO@yahoogroups.com
[mailto:CAD_CAM_EDM_DRO@yahoogroups.com] On Behalf Of Steve Blackmore



124 lines of unnecessary quoting removed for a three word post!!!! It's
not hard to remove the dross out of your replies, a couple of keystrokes
and we don't have to download the same stuff all over again!

Embarrassingly, my reply is a two liner..

Why don't you and Jon get together, bite the bullet and use his hardware
and EMC2? Or spend £7500 and have a solution tomorrow?

Steve Blackmore





[Non-text portions of this message have been removed]