CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] looking for some gearheads

Posted by H & J Johnson
on 2007-07-28 20:15:37 UTC
> At 05:07 PM 7/28/2007, you wrote:
> >I need a couple of 90 degree gearheads,
> >I can use ratio between 7:1 to 15:1
> >frame size 34 or 42 or metric size 90 or 115
>
> While not exactly "off list", take a look at www.surpluscenter.com
> in
> their "power transmission" "gear reducer" section.
>
> They are not cheap ($100-$200 for smaller ones), but you might
> find
> what you want. This is of general interest, or it would have been
> off list.
>
>
> David G. LeVine
> Nashua, NH 03060

Don't use these, you'll just be wasting you money. None of them at
I could see on the four pages listed are precision reducers.. only use
these if your looking for lots of backlash for your system..
Search ebay for Precision Gearhead Planetary... you'll get several..
be patient.. I've bought 3 thompson 10:1 34's for $75 ttl off ebay...
there are deals if you are careful and patient..

Jarrett

Discussion Thread

carlcnc 2007-07-28 14:08:45 UTC looking for some gearheads David G. LeVine 2007-07-28 14:21:48 UTC Re: [CAD_CAM_EDM_DRO] looking for some gearheads Mark Vaughan 2007-07-28 14:39:44 UTC RE: [CAD_CAM_EDM_DRO] looking for some gearheads Graham Stabler 2007-07-28 15:50:24 UTC Re: looking for some gearheads H & J Johnson 2007-07-28 20:15:37 UTC Re: [CAD_CAM_EDM_DRO] looking for some gearheads David G. LeVine 2007-07-29 15:48:43 UTC Re: [CAD_CAM_EDM_DRO] looking for some gearheads H & J Johnson 2007-07-30 14:32:35 UTC Re: [CAD_CAM_EDM_DRO] looking for some gearheads Jon Elson 2007-07-30 19:09:57 UTC Re: [CAD_CAM_EDM_DRO] looking for some gearheads David G. LeVine 2007-07-30 21:28:38 UTC Re: [CAD_CAM_EDM_DRO] looking for some gearheads Mark Vaughan 2007-07-31 01:29:36 UTC RE: [CAD_CAM_EDM_DRO] looking for some gearheads scyvt 2007-07-31 04:29:05 UTC Re: looking for some gearheads