CAD CAM EDM DRO - Yahoo Group Archive

Re: Newbie Question

Posted by Jack Mc Kie
on 2007-08-02 10:00:12 UTC
Ron,

The way I read it, and reread it, it needs only power supplies 12VDC,
and 5VDC, wires, and steppers??? What am I missing?

The more I try to ferret out info the more complicated it gets!

I am leaning toward the Xylotex controller though I will have to look
at the Hobby CNC controller.

Jack

> > Jack
>
> You are mixing apples and oranges here- the Xylotex is a driver
board-
> think of it as the power amplifier to drive motors. The deskcnc is
a
> signal generator- it does the real time pulse generation, it needs
a
> power amp, like the Xylotex or one of several other boards.
>
> The deskcnc function can be done in software if you use Mach3 or
EMC2.
> You will need the Xylotex in either case, hooked to a parallel port
in
> the PC.
>
> Deckcnc uses a serial port to the PC
>
> ron ginger
>

Discussion Thread

Steve Greenfield 2000-11-29 09:00:38 UTC Re: Newbie Question Wally K 2000-11-29 09:28:25 UTC Saving links san3@s... 2001-07-13 01:37:31 UTC Newbie Question cncdxf@a... 2001-07-13 06:22:41 UTC Re: Newbie Question Tim Goldstein 2001-07-13 07:09:53 UTC RE: [CAD_CAM_EDM_DRO] Newbie Question kimvellore 2002-08-21 12:52:13 UTC Newbie Question Tom Benedict 2002-08-21 13:11:10 UTC Re: [CAD_CAM_EDM_DRO] Newbie Question j.guenther 2002-08-21 13:11:10 UTC RE: [CAD_CAM_EDM_DRO] Newbie Question teleteq 2005-05-11 14:33:32 UTC Newbie Question Codesuidae 2005-05-11 15:30:17 UTC Re: [CAD_CAM_EDM_DRO] Newbie Question turbulatordude 2005-05-11 15:58:55 UTC Re: Newbie Question Dave Shiels 2005-05-11 16:21:21 UTC Re: [CAD_CAM_EDM_DRO] Newbie Question teleteq 2005-05-11 16:43:53 UTC Re: Newbie Question Jack Mc Kie 2007-08-01 14:56:18 UTC Newbie Question Ron Ginger 2007-08-02 06:35:33 UTC Re: Newbie Question turbulatordude 2007-08-02 07:25:07 UTC Re: Newbie Question - mini-mill conversion Jack Coats 2007-08-02 07:53:37 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie Question Jack Mc Kie 2007-08-02 10:00:12 UTC Re: Newbie Question Graham Stabler 2007-08-02 11:13:44 UTC Re: Newbie Question Jack Mc Kie 2007-08-02 11:40:11 UTC Re: Newbie Question