Re: [CAD_CAM_EDM_DRO] Re: Retrofit bridgeport
Posted by
Leslie Newell
on 2007-08-24 11:02:54 UTC
I retrofitted my Boss5 a while back After a protracted and expensive
battle trying to get the original steppers to work I bit the bullet and
fitted DC servos. It now works brilliantly.
The motors are cheap treadmill motors from www.surpluscenter.com with
encoders fitted. They work remarkably well. I have a lathe is fitted
with proper DC servos and to be honest I can't say they perform any
better than the treadmill motors, apart from the fact they have more
torque. The only disadvantage with treadmill motors is that you have to
gear them down about 4:1 instead of the original 1:1 or 2:1.
Les
Peter Rosenholm wrote:
battle trying to get the original steppers to work I bit the bullet and
fitted DC servos. It now works brilliantly.
The motors are cheap treadmill motors from www.surpluscenter.com with
encoders fitted. They work remarkably well. I have a lathe is fitted
with proper DC servos and to be honest I can't say they perform any
better than the treadmill motors, apart from the fact they have more
torque. The only disadvantage with treadmill motors is that you have to
gear them down about 4:1 instead of the original 1:1 or 2:1.
Les
Peter Rosenholm wrote:
> Thanks, I recall having DC servos, now they have AC servos? How much did it cost in the end, and did you use a Retrofit kit? The motors and encoders had to be expensive?
> Peter Rosenholm
>
Discussion Thread
vrsculptor
2007-08-19 20:08:09 UTC
3D Printing engine discoveries
Graham Stabler
2007-08-20 07:06:24 UTC
Re: 3D Printing engine discoveries
vrsculptor
2007-08-20 07:24:37 UTC
Re: 3D Printing engine discoveries
Graham Stabler
2007-08-20 09:19:30 UTC
Re: 3D Printing engine discoveries
Peter Rosenholm
2007-08-21 00:32:52 UTC
Retrofit bridgeport
vavaroutsos
2007-08-23 23:53:21 UTC
Re: Retrofit bridgeport
Peter Rosenholm
2007-08-24 10:01:15 UTC
Re: [CAD_CAM_EDM_DRO] Re: Retrofit bridgeport
Leslie Newell
2007-08-24 11:02:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: Retrofit bridgeport
Jack Ensor
2007-08-25 11:07:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: Retrofit bridgeport
vavaroutsos
2007-08-26 19:49:24 UTC
Re: Retrofit bridgeport