Re: tachogenerator
Posted by
bondeoca
on 2008-11-04 01:57:41 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Jon Elson <elson@...> wrote:
dc motor can be run as a generator and visa versa. Do you know how
the windings differ from a dc motor?
Rick
>spindle
> bondeoca wrote:
> > Hello All
> > I have picked up a G E tachogenerator hoping to use it as a
> > drive motor for my mill.in
> > It is a pm rated at 100 volts per 1000 rpm.It is apprx . 7 inches
> > dia. and 10 inches long,hasdirection.
> > four brushes 180 degree spacing. When I apply 100 volts it
> > rotates ,but with a 2 inch pulley
> > on the shaft I can stop it by hand a turn it in the opposite
> > So my question is , is there something I can easily do to thismotor
> > to increase its torque?very
> > I also notice the magnets for being quite large , do not seem
> > strong.accurately
> >
> It is NOT a motor! It is a measuring instrument, designed to
> measure the speed of some mechanism.motor,
> Since all electrical machines are reversible, it is similar to a
> but it is optimized all wrong for use AS a motor.Thanks Jon, I knew it wasn't a motor ,but a lot of sites say any
> Other than replacing the magnets and windings, I think it will be
> impossible to make it function well as a motor.
>
> Jon
>
dc motor can be run as a generator and visa versa. Do you know how
the windings differ from a dc motor?
Rick
Discussion Thread
bondeoca
2008-11-03 16:13:50 UTC
tachogenerator
Jon Elson
2008-11-03 22:18:02 UTC
Re: [CAD_CAM_EDM_DRO] tachogenerator
bondeoca
2008-11-04 01:57:41 UTC
Re: tachogenerator
dgoadby
2008-11-04 08:22:06 UTC
Re: tachogenerator
Jon Elson
2008-11-04 09:14:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: tachogenerator
bondeoca
2008-11-04 16:31:34 UTC
Re: tachogenerator
Jon Elson
2008-11-04 19:20:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: tachogenerator
Tom Hubin
2008-11-05 03:12:45 UTC
Video Probe Software
Kim Mortensen
2008-11-05 03:20:06 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Kim Mortensen
2008-11-05 03:29:23 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Tom Hubin
2008-11-05 03:34:15 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Tom Hubin
2008-11-05 03:42:05 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Kim Mortensen
2008-11-05 03:51:23 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Tom Hubin
2008-11-05 14:41:39 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software