Re: [CAD_CAM_EDM_DRO] Video Probe Software
Posted by
Kim Mortensen
on 2008-11-05 03:51:23 UTC
Tom,
Thanks for the answers.
As a SW Developper, just querious how the SW does the job. what scan
methods/filter do you use. is there any help you can give me if I want to
persue the same path.
Best Regards
Kim Mortensen
2008/11/5 Tom Hubin <thubin@...>
Thanks for the answers.
As a SW Developper, just querious how the SW does the job. what scan
methods/filter do you use. is there any help you can give me if I want to
persue the same path.
Best Regards
Kim Mortensen
2008/11/5 Tom Hubin <thubin@...>
> Hello kim,[Non-text portions of this message have been removed]
>
> > - How does it tackle slopes that is parallel to the laser.
>
> That is usually going to produce useless data. You do need to be aware
> enough of the type and orientation of surfaces to avoid problems.
> Ideally you would scan the part with the probe or with the part in a
> variety of orientations, then stitch the the resulting point clouds
> together with magic software.
>
> > - Are reflections of the object a problem for the software.
>
> If you have a mirror like surface and the beam reflects without
> scattering then you can have problems. It may be necessary to alter the
> surface so that it is not mirror-like. That can involve sanding or sand
> blasting or painting if you don't mind doing something permanent. Or you
> can dust the surface with talcum powder or flour or paint with water
> colors if you don't mind cleaning it afterward.
>
> Tom Hubin
> thubin@... <thubin%40earthlink.net>
>
>
>
Discussion Thread
bondeoca
2008-11-03 16:13:50 UTC
tachogenerator
Jon Elson
2008-11-03 22:18:02 UTC
Re: [CAD_CAM_EDM_DRO] tachogenerator
bondeoca
2008-11-04 01:57:41 UTC
Re: tachogenerator
dgoadby
2008-11-04 08:22:06 UTC
Re: tachogenerator
Jon Elson
2008-11-04 09:14:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: tachogenerator
bondeoca
2008-11-04 16:31:34 UTC
Re: tachogenerator
Jon Elson
2008-11-04 19:20:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: tachogenerator
Tom Hubin
2008-11-05 03:12:45 UTC
Video Probe Software
Kim Mortensen
2008-11-05 03:20:06 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Kim Mortensen
2008-11-05 03:29:23 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Tom Hubin
2008-11-05 03:34:15 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Tom Hubin
2008-11-05 03:42:05 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Kim Mortensen
2008-11-05 03:51:23 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software
Tom Hubin
2008-11-05 14:41:39 UTC
Re: [CAD_CAM_EDM_DRO] Video Probe Software