Re: [CAD_CAM_EDM_DRO] Re: Cam program and post needed for a cnc propellor carving lathe
Posted by
gcode fi (hanermo)
on 2009-01-29 14:45:24 UTC
Very complicated. Very.
Titanium blanks, primary (basic) machined, cast in soft molten metal
when pre-machined...finish machined... remelted to clean off the other
metal ...
Multiple inspections.
I saw this somewhere ... unbelievable process.
It´s because real big or important turbine blades will cause great havoc
and loss of life. In jet fighters etc.
They are very complex to do. A single damaged blade (*may*) cost 60m$ if
it fails, so ...
The mig fighter blades I saw were about a foot long (per leaf !) and
could spin at near 100k rpm.
D was over 2 ft.
The tension at 1000 degrees c or so and at 100.000 rpm is great ... vbg
Titanium blanks, primary (basic) machined, cast in soft molten metal
when pre-machined...finish machined... remelted to clean off the other
metal ...
Multiple inspections.
I saw this somewhere ... unbelievable process.
It´s because real big or important turbine blades will cause great havoc
and loss of life. In jet fighters etc.
They are very complex to do. A single damaged blade (*may*) cost 60m$ if
it fails, so ...
The mig fighter blades I saw were about a foot long (per leaf !) and
could spin at near 100k rpm.
D was over 2 ft.
The tension at 1000 degrees c or so and at 100.000 rpm is great ... vbg
>
>
> How do the big guys make turbine blades???
>
> Jack
>
Discussion Thread
Larry
2009-01-29 10:27:36 UTC
Cam program and post needed for a cnc propellor carving lathe
Jack McKie
2009-01-29 10:32:18 UTC
Re: [CAD_CAM_EDM_DRO] Cam program and post needed for a cnc propellor carving lathe
Larry
2009-01-29 10:49:41 UTC
Re: Cam program and post needed for a cnc propellor carving lathe
Jack Mc Kie
2009-01-29 13:08:27 UTC
Re: Cam program and post needed for a cnc propellor carving lathe
gcode fi (hanermo)
2009-01-29 14:45:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: Cam program and post needed for a cnc propellor carving lathe
Gary Corlew
2009-01-29 18:45:14 UTC
RE: Re: Cam program and post needed for a cnc propellor carving lathe
Roland Jollivet
2009-01-30 05:06:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: Cam program and post needed for a cnc propellor carving lathe
cafeagle
2009-01-30 08:44:06 UTC
Re: Cam program and post needed for a cnc propellor carving lathe
Fred Smith
2009-01-31 08:21:32 UTC
Re: Cam program and post needed for a cnc propellor carving lathe