Re: [CAD_CAM_EDM_DRO] Mach3 problem

--- On Thu, 3/12/09, Steve Blackmore <steve@...> wrote:


From: Steve Blackmore <steve@...>
Subject: Re: [CAD_CAM_EDM_DRO] Mach3 problem
To: CAD_CAM_EDM_DRO@yahoogroups.com
Date: Thursday, March 12, 2009, 6:44 PM






On Thu, 12 Mar 2009 18:06:42 -0000, you wrote:

>I have two computers with Mach3 mill ver 3.00 . The code below runs fine in Mach3 in one computer but not in the other. In the computer set up on my mill I get a flashing "abnormal condition" light. The code is fine. What is causing this in Mach3??? I assume something is set differently but don't have a clue where to look.

If you click on the flashing warning it tells you what the abnormal
condition is.

Steve Blackmore
--


















[Non-text portions of this message have been removed]