Re: [CAD_CAM_EDM_DRO] Mach3 problem
Posted by
Steve Blackmore
on 2009-03-13 13:43:08 UTC
On Fri, 13 Mar 2009 04:26:05 -0700 (PDT), you wrote:
is corrupt.
Check the default in Config/General Config - Motion mode. If they are
both the same, copy the XML from the "good" pc to the "bad" PC.
Steve Blackmore
--
>OK, then why does it not do that on another computer? Same Mach3. I think either I did something to muck up the works or possibly something has changed.Because the default CV setting differs on each of the PC's, or your XML
is corrupt.
Check the default in Config/General Config - Motion mode. If they are
both the same, copy the XML from the "good" pc to the "bad" PC.
Steve Blackmore
--
Discussion Thread
Jack Mc Kie
2009-03-12 11:06:44 UTC
Mach3 problem
Henrik Olsson
2009-03-12 11:20:29 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Steve Blackmore
2009-03-12 15:44:26 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Jack McKie
2009-03-12 17:59:47 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Steve Blackmore
2009-03-13 01:18:57 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Jack McKie
2009-03-13 04:26:09 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Lester Caine
2009-03-13 04:43:37 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Jack McKie
2009-03-13 06:37:49 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Lester Caine
2009-03-13 07:07:48 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Jack McKie
2009-03-13 08:57:43 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Henrik Olsson
2009-03-13 09:18:55 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Stephen Wille Padnos
2009-03-13 09:44:20 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Jack McKie
2009-03-13 09:58:57 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Steve Blackmore
2009-03-13 13:43:08 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Steve Blackmore
2009-03-13 13:44:04 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Steve Blackmore
2009-03-13 13:45:24 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem
Stephen Wille Padnos
2009-03-13 13:47:48 UTC
Re: [CAD_CAM_EDM_DRO] Mach3 problem