Re: [CAD_CAM_EDM_DRO] Mach3 problem

Henrik Olsson wrote:

>Jack,
>It's not a problem, it's a feature.
>If you setup Mach3 to run in CV mode by selecting Constant Velocity (G64) in
>Config->General Config and your G-code then CHANGES motion mode to Exact
>Stop (G61) or vice versa the Abnormal condition light will turn on.
>
>If your code is supposed to do that it's nothing to worry about. The warning
>will go away when you or the code switches back to the initial motion mode.
>
>

I know nothing about how to configure Mach, but my understanding of the
problem is that on one machine, the warning light never comes on, and on
the other he can change when the warning occurs by changing the default
contouring mode. Unless there's a setup option to disable certain
warnings, this is unexplained behavior.

Of course, I'm boggled that it would be considered anything to warn you
about in any case, since the G-code in question explicitly sets the
contouring mode.

- Steve