Re: Torch Table

How are you supporting the slats ? My first plasma table was similar to
this and the slats could wobble a bit, being only supported at each end
(They were made of 75 x 3mm flat bar). If the metal being cut was
bumped, or the torch touched it, all accuracy was lost. It would help to
put another support through the middle at 90 degrees if this happens.
I used a Thermal Dynamics Cutmaster 101 and it worked well - cheaper
than Hypertherm. Use a Pilot Arc Plasma Cutter - which ever brand you
choose. ( Less electrical noise )
Regards,
Glen.
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "jeremymaso" <jeremymaso@...>
wrote:

>
> Hi, we're working on a torch table design and are looking for some

feedback on it. We have some pictures of the latest design on the top
right side of the project page, and the bill of materials is near the
bottom: http://openfarmtech.org/index.php?title=Torch_table

>
> We still need to source a torch for it, any recommendations?
>
> Thanks for any feedback!
>