Wire gauge for wiring cnc controllers
Posted by
wanliker@a...
on 2010-09-22 09:30:36 UTC
One problem with the very fine wires is that if you solder it, it will have
a tendency to break right at the end of the solder joint. If you do need
to solder it, then anchor the wire an inch or so away from the joint to
stop the flexing at the joint. This would be a good idea with most flexible
wires, unless there is a connector that is tightly clamped on the wire
bundle.
bill
In a message dated 9/22/2010 3:32:47 A.M. Mountain Daylight Time,
ajsmith@... writes:
Someone previously mentioned flexibility depends on the number of strands
in
the wire, and that's correct. I've got some wire with 512 strands, and it's
very flexible.
[Non-text portions of this message have been removed]
a tendency to break right at the end of the solder joint. If you do need
to solder it, then anchor the wire an inch or so away from the joint to
stop the flexing at the joint. This would be a good idea with most flexible
wires, unless there is a connector that is tightly clamped on the wire
bundle.
bill
In a message dated 9/22/2010 3:32:47 A.M. Mountain Daylight Time,
ajsmith@... writes:
Someone previously mentioned flexibility depends on the number of strands
in
the wire, and that's correct. I've got some wire with 512 strands, and it's
very flexible.
[Non-text portions of this message have been removed]
Discussion Thread
Brian
2010-09-18 00:17:35 UTC
Wire gauge for wiring cnc controllers
Danny Miller
2010-09-18 02:35:47 UTC
Re: [CAD_CAM_EDM_DRO] Wire gauge for wiring cnc controllers
Tony Smith
2010-09-18 04:09:43 UTC
RE: [CAD_CAM_EDM_DRO] Wire gauge for wiring cnc controllers
Lester Caine
2010-09-18 06:27:22 UTC
Re: [CAD_CAM_EDM_DRO] Wire gauge for wiring cnc controllers
Randy Abernathy
2010-09-18 08:01:50 UTC
RE: [CAD_CAM_EDM_DRO] Wire gauge for wiring cnc controllers
Dan Mauch
2010-09-18 09:05:26 UTC
Wire gauge for wiring cnc controllers
turbulatordude
2010-09-18 09:19:06 UTC
Re: Wire gauge for wiring cnc controllers
Dave Halliday
2010-09-21 23:00:11 UTC
RE: [CAD_CAM_EDM_DRO] Wire gauge for wiring cnc controllers
Brian Worth
2010-09-22 01:15:27 UTC
Re: [CAD_CAM_EDM_DRO] Wire gauge for wiring cnc controllers
Danny Miller
2010-09-22 01:42:07 UTC
Re: [CAD_CAM_EDM_DRO] Wire gauge for wiring cnc controllers
Tony Smith
2010-09-22 02:32:43 UTC
RE: [CAD_CAM_EDM_DRO] Wire gauge for wiring cnc controllers
wanliker@a...
2010-09-22 09:30:36 UTC
Wire gauge for wiring cnc controllers