RE: [CAD_CAM_EDM_DRO] Help I need a Dwg. or information

Hi All:
     I am way behind in getting this lathe running as I need it to make parts due last month. 
I have run into a problem in trying to find DWG #3432  on this motor control.  This drawing
shows how jumpers #17 and #22 are left for 220 volt operation of the motor.  At present
the jumpers are solid bare wires soldered right into the circuit board.  I need to know which
if any I need to cut out for 220 Volt operation of the motor.

       Motor Control by Randtronics Inc 1975  Assy #3432-240-512  SN - 665EA

The control is for the DC 10 HP spindle motor to the following lathe

                               CADILLAC NC-100 LATHE
              
                   With General Numeric System 5T-2 Microprocessor

       Made in Taiwan by Yam    Model #2233      Mfg # 867354

When the machine was received this warning note was on the tape reader
        

                      Jumper R17 & R22 on motor drive

                      See Dwg #3432   MUST CHANGE FOR 220V ! ! !

Any help with the drawing or what to do will be GREATLY APPRECIATED

                                                  GOD'S BLESSINGS
                                                             Bill




[Non-text portions of this message have been removed]