Re: tool size > hole dia
Posted by
Dave Sage
on 2011-04-05 05:10:07 UTC
I tried what you said and I get the same error only when the tool diameter
is the .312 and the radius of the circle is also .312. This I'm sure you can
understand why this is. But if I change the tool to be only .311 diameter to
prove a point it works fine. BUT initially I noticed the same problem as you
with a couple of smaller tool sizes.
With all the switching of screens to get back to the tool
diameter entry screen I was forgetting to press ENTER after putting in the
new tool size. If you don't remember to press ENTER the tool size will not
take and will revert back to what was there before (.312)
Try it again and be sure to press ENTER after inserting
information into any of the wizard boxes. This a very annoying "feature" of
all the wizard. Even clicking on a new box does not lock-in the current
information. You must press ENTER.
Sage
[Non-text portions of this message have been removed]
is the .312 and the radius of the circle is also .312. This I'm sure you can
understand why this is. But if I change the tool to be only .311 diameter to
prove a point it works fine. BUT initially I noticed the same problem as you
with a couple of smaller tool sizes.
With all the switching of screens to get back to the tool
diameter entry screen I was forgetting to press ENTER after putting in the
new tool size. If you don't remember to press ENTER the tool size will not
take and will revert back to what was there before (.312)
Try it again and be sure to press ENTER after inserting
information into any of the wizard boxes. This a very annoying "feature" of
all the wizard. Even clicking on a new box does not lock-in the current
information. You must press ENTER.
Sage
[Non-text portions of this message have been removed]
Discussion Thread
ebiz_59
2011-04-04 10:36:45 UTC
tool size > hole dia
Andy Wander
2011-04-04 10:40:33 UTC
RE: [CAD_CAM_EDM_DRO] tool size > hole dia
Chuck Merja
2011-04-04 11:06:50 UTC
RE: [CAD_CAM_EDM_DRO] tool size > hole dia
Ron Thompson
2011-04-04 11:22:53 UTC
Re: [CAD_CAM_EDM_DRO] tool size > hole dia
Dave Sage
2011-04-05 05:10:07 UTC
Re: tool size > hole dia
Chuck Merja
2011-04-05 10:11:33 UTC
RE: [CAD_CAM_EDM_DRO] Re: tool size > hole dia
Stephen Muscato
2011-04-05 14:58:11 UTC
Re: [CAD_CAM_EDM_DRO] tool size > hole dia
Dave Sage
2011-04-06 09:16:31 UTC
Re: tool size > hole dia