Re: [CAD_CAM_EDM_DRO] Dolphin Partmaster

Bob Cad is rough around the egdes. I would like to try Dolphin. I have spoken with them, just have not made the jump.
Bob Cad V24 is easier than V23, in the milling mode, but lathe mode is near  the same as V23. I use it every day and it works just fine. I think what you get used to simply remains easy.
I'm only tempted to try another software because I read how others say "this" is best or "that" is best.
Over the years I've learned a number of Cad programs, Generic, Turbo, AutoCad, Autocad lite, Draftsite, Bob Cad,  and I may have forgotten some. Each one had features I liked, and features I didn't like, or even use.

Denis

--- On Thu, 6/30/11, Jack McKie <freshwatermodels@...> wrote:

From: Jack McKie <freshwatermodels@...>
Subject: Re: [CAD_CAM_EDM_DRO] Dolphin Partmaster
To: CAD_CAM_EDM_DRO@yahoogroups.com
Date: Thursday, June 30, 2011, 9:15 AM
















 









I tried BobCAD and couldn't figure it out.    I was able to learn Rhino so that is what I will stick with.   Another interesting CAD program is Moi which is very intuative.

 

Jack



--- On Thu, 6/30/11, sunny00dayz <sunny00dayz@...> wrote:



From: sunny00dayz <sunny00dayz@...>

Subject: [CAD_CAM_EDM_DRO] Dolphin Partmaster

To: CAD_CAM_EDM_DRO@yahoogroups.com

Date: Thursday, June 30, 2011, 9:54 AM



 



About a month or two ago I posted on here asking for any advice on Dolphin CAD/CAM. I didn't receive much feedback so just wanted to chime in quick. For the past few years I tinkered with Bobcad, and never made it very far. It claims the game, so unless I am a complete idiot, the software just failed to produce much for me. A month after buying Dolphin, I must admit I have gotten way further then what BCC allowed me to. They dont have the rastor to vector which was nice, but outside of that I find it very nice and easy.



[Non-text portions of this message have been removed]



























[Non-text portions of this message have been removed]