Re: [CAD_CAM_EDM_DRO] Re: CAD2lathe software

Jack,
After reading this post again, I remembered that
Bob did a youtube video on how to use the program.

http://www.youtube.com/watch?v=L77a0BfYnGE

Hope this helps.

art
Country Bubba

At 02:46 PM 8/9/2011, you wrote:

>Ron,
>Â
>Yes, I have written G code for a mill (now use
>Rhinocam) and could probably learn to do lathe.Â
>Â Some stuff I do isn't just lines and arcs so
>need something to handle what Rhino calls a
>curve.   I don't enjoy writing code and
>mostly just need to get the part or pattern made.
>Â
>I was hoping that cad2lathe would just make
>things a bit simpler than writing code but that
>may not be the case.   I think that with a
>bit of development, especially explanation of
>software requirements, trouble shooting infoÂ
>and step by step instructions, cad2lathe would
>be better.  I'll probably fool with it a bit
>more to see if I can get it to work.  Being a
>Rhino user, I think it might be a great plug in
>for Rhino since there isn't any rhinocam for lathe yet.
>Â
>Jack