Re: G-Codes to Stepper Pulses?

Charlie,

Can't make 5 go. Get an error message and bails out. Tried on a dos machine
and
a w95 machine.

Bob

At 09:14 PM 7/2/99 -0400, you wrote:

>From: Charles Gallo <Charlie@...>
>
>Bob,
> Sorry, only 5 is up, six is here at home
>
>Charlie
>
>At 09:21 PM 7/1/99, you wrote:
>>From: Bob Bachman <bobach@...>
>>
>>Charlie,
>>
>>Can't find it on your site. Where is it located? Found build5 though.
>>
>>Bob
>>
>>> Actually, build 6 is on my web site - http://www.thegallos.com
>>>
>>
>>
>>
>>--------------------------- ONElist Sponsor ----------------------------
>>
>>Find people who care about what you care about.
>>http://www.onelist.com
>>At ONElist: your connection to community.
>>
>>------------------------------------------------------------------------
>>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the
>discussion of shop built systems in the above catagories.
>>To Unsubscribe, read archives, change to or from digest.
>>Go to: http://www.onelist.com/isregistered.cgi
>>Log on, and you will go to Member Center, and you can make changes there.
>>bill,
>>List Manager
>>
>>
>PGP Key Avalible upon request
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
>Campaign 2000 is here!
>http://www.onelist.com
>Discuss your thoughts; get informed at ONElist. See our homepage.
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>bill,
>List Manager
>
>