CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Ball Screw Disassembly

Posted by Matt Shaver
on 2000-10-30 14:40:25 UTC
Tim Goldstein wrote:

> Of course there is another option. Just let the balls fall out into a dish
> and learn to reload the nut on assembly.

Some ball screws use two different size balls (different by only a ten
thousandth of an inch or so), and are loaded big ball, small ball. big
ball, small ball, etc. This is to help assure that the balls roll rather
than slide.

Matt

There's a long way between "it works", and "it's right".

Discussion Thread

beer@s... 2000-10-30 09:23:15 UTC Ball Screw Disassembly Tim Goldstein 2000-10-30 10:38:36 UTC RE: [CAD_CAM_EDM_DRO] Ball Screw Disassembly r_fl_z@h... 2000-10-30 11:51:13 UTC Re: Ball Screw Disassembly ptengin@a... 2000-10-30 12:13:55 UTC Re: [CAD_CAM_EDM_DRO] Re: Ball Screw Disassembly ballendo@y... 2000-10-30 13:04:02 UTC re:Ball Screw Disassembly ballendo@y... 2000-10-30 13:18:15 UTC Re: Ball Screw Disassembly Wally K 2000-10-30 13:51:36 UTC Re: Ball Screw Disassembly stratton@m... 2000-10-30 13:52:49 UTC Re: [CAD_CAM_EDM_DRO] re:Ball Screw Disassembly Matt Shaver 2000-10-30 14:40:25 UTC Re: [CAD_CAM_EDM_DRO] Ball Screw Disassembly JanRwl@A... 2000-10-30 15:09:00 UTC Re: [CAD_CAM_EDM_DRO] Ball Screw Disassembly Jon Elson 2000-10-30 15:23:50 UTC Re: [CAD_CAM_EDM_DRO] Re: Ball Screw Disassembly ballendo@y... 2000-10-30 16:42:39 UTC re:Re: Ball Screw Disassembly Ian Wright 2000-10-30 17:00:22 UTC Re: [CAD_CAM_EDM_DRO] re:Ball Screw Disassembly Anne Ogborn 2000-10-30 22:31:00 UTC Re: [CAD_CAM_EDM_DRO] Ball Screw Disassembly