Re: [CAD_CAM_EDM_DRO] Re: Cheap DRO system using digital scales and a PC

Lee;
please forward your e mail address to
diazden@...
I will send you the panflet in about 14 hours from now (I got it at work)
regards
mariano


Lee Studley wrote:

> mariano
> Please Do!!!!!
> Thanks,
> -Lee
>
> -- In CAD_CAM_EDM_DRO@egroups.com, diazden <diazden@o...> wrote:
> > Lee; I can send you the mitutoyo pamphlet that contains all the
> data that you want
> > regards
> > mariano
> >
> >
> > Lee Studley wrote:
> >
> > > Hi,
> > >
> > > Well my 1st attempt has deepened the puzzle. I was wrong about the
> > > async format. I found 2 bursts of data syncronous with the clock
> > > at 2 sections of 24 bits clocked out at a rate of 13uS per bit.
> > > These 48bit packets are transmitted at 6.3hz or 158.7 mS apart.
> > >
> > > Next I'll rigg up a Pic to sample the data and transmit an ascii
> 0 or
> > > 1 via async format depending on the bits it samples and log the
> data
> > > using hyperterm. It didnt appear that all the data is contained in
> > > the 48bit bursts, so it may be a series of data as the article
> > > describes. The data rate is much higher then the articles
> > > description. I'm suspecting that different manufactures may
> > > use different proprietary formats.
> > >
> > > I'll share my findings, as soon as I find some time to rig
> > > the setup.
> > > -Lee
> > >
> > > Welcome to CAD_CAM_EDM_DRO@e...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
> > >
> > > Addresses:
> > > Post message: CAD_CAM_EDM_DRO@egroups.com
> > > Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> > > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> > > List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@a...
> > > Moderator: jmelson@a... [Moderator]
> > > URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> > > FAQ: http://www.ktmarketing.com/faq.html
> > > bill,
> > > List Manager
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager