Re: [CAD_CAM_EDM_DRO] Old DOS boot disk for W95?

More thing to try.


Are you sure your jumper settings are correct. Give me the make and model
and I can look them up.

Connect up the hard drive and boot from a floppy, any version of DOS 3.x to
6.22 or use your Win9x install floppy.

If using Win9x floppy hit shift + F5 which will drop you to a DOS prompt.

Make sure you have the FDISK program on the floppy.

run FDISK and see if it sees the hard drive and if so what partitions are on
it.

Hugh

----- Original Message -----
From: Jon Anderson <janders@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Sunday, December 03, 2000 2:32 PM
Subject: Re: [CAD_CAM_EDM_DRO] Old DOS boot disk for W95?


> Smoke wrote:
> >
> > Did you try the HD in another machine?
>
> No, but will take the time to try that before I scrap it.
> It was a cheap HD, but if all I get out of it are a couple bearings,
> they're gonna be fairly expensive bearings...<G>
>
> Jon
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>