CAD CAM EDM DRO - Yahoo Group Archive

Re: Re: Re: CNC router Z axis travel

Posted by ballendo@y...
on 2000-12-11 14:08:34 UTC
Smoke,

C'mon!

First, You bust my butt in a message saying I've got it all wrong, my
advice is TOO limiting, saying you have a better way...

Then you say you're too busy to let us know the better way???

Second, You told us (when we were talking about leadscrew cost) that
you could use a six foot screw to get a 10' travel. We called you on
it, and you posted to the files section something which clearly does
not work... Now you say that it's going to take a hollow
ballscrew!?!?

Saying you THINK something MIGHT work is a whole lot different than
what you've been saying.

If this were a poker game, I just called your hand...

Ballendo

P.S. I believe you have talent and enjoy your input to the group. I
am watching the 'dream machines' take shape. I wish you luck and
success.

>Actually, I now have two methods to make the screw work. However,
>if your looking to save a lot of money your out of luck! The first
>method requires a special ball screw. <snip>
>Smoke

Discussion Thread

ballendo@y... 2000-12-10 16:24:03 UTC CNC router Z axis travel Joe Vicars 2000-12-10 17:04:58 UTC Re: CNC router Z axis travel Smoke 2000-12-10 17:19:18 UTC Re: [CAD_CAM_EDM_DRO] CNC router Z axis travel ballendo@y... 2000-12-10 19:01:02 UTC Re: CNC router Z axis travel Smoke 2000-12-10 20:14:38 UTC Re: [CAD_CAM_EDM_DRO] Re: CNC router Z axis travel ballendo@y... 2000-12-10 21:40:57 UTC Re: Re: CNC router Z axis travel Smoke 2000-12-11 07:25:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: CNC router Z axis travel ballendo@y... 2000-12-11 14:08:34 UTC Re: Re: Re: CNC router Z axis travel Smoke 2000-12-11 14:24:37 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: Re: CNC router Z axis travel Ian Wright 2000-12-11 16:17:12 UTC Re: [CAD_CAM_EDM_DRO] CNC router Z axis travel Jon Anderson 2000-12-11 17:01:44 UTC Re: [CAD_CAM_EDM_DRO] CNC router Z axis travel Ian Wright 2000-12-12 01:16:08 UTC Re: [CAD_CAM_EDM_DRO] CNC router Z axis travel Jon Anderson 2000-12-12 09:01:55 UTC Re: [CAD_CAM_EDM_DRO] CNC router Z axis travel