CAD CAM EDM DRO - Yahoo Group Archive

Re: YAK (digitizer YAK at that)

Posted by Lee Studley
on 2001-01-15 10:58:48 UTC
Hi Jon,
The 555 circuit a can be found at Radio Shack in the little engineer
booklet. It goes over the monostable or 'one-shot' circiut and others.
Debounce can also be done many ways, my preference is with a 74HC14
device and R and C's.

I'll draw a schematic for several ways tonight and post a link to it.

-Lee



--- In CAD_CAM_EDM_DRO@egroups.com, Jon Anderson <janders@n...> wrote:
> Tom,
>
> I'd rather not take it off list either, but when folks start
complaining
> about a topic that bores them, it seems the topic quickly dies. I'd
like
> to be able to digitize and want to see a working home-shop buildable
> probe become reality. Some drawings and schematics are all that
stand in
> the way. Better that development continue off list than die
altogether.
> Better still if we can continue onlist though.
>
> Jon

Discussion Thread

Jon Anderson 2001-01-14 10:11:36 UTC Re: YAK (digitizer YAK at that) Tom Eldredge 2001-01-15 06:49:17 UTC Re: [CAD_CAM_EDM_DRO] Re: YAK (digitizer YAK at that) Roman Black 2001-01-15 07:53:00 UTC Re: YAK (digitizer YAK at that) Jon Anderson 2001-01-15 10:32:52 UTC Re: [CAD_CAM_EDM_DRO] Re: YAK (digitizer YAK at that) Jon Anderson 2001-01-15 10:35:18 UTC Re: [CAD_CAM_EDM_DRO] Re: YAK (digitizer YAK at that) Lee Studley 2001-01-15 10:58:48 UTC Re: YAK (digitizer YAK at that) Jon Anderson 2001-01-15 12:12:12 UTC Re: [CAD_CAM_EDM_DRO] Re: YAK (digitizer YAK at that) Carlos Guillermo 2001-01-15 18:35:27 UTC digitizer design and FAB PMeinhard@a... 2001-01-16 03:58:54 UTC Re: [CAD_CAM_EDM_DRO] digitizer design and FAB Roman Black 2001-01-16 04:46:01 UTC Re: YAK (digitizer YAK at that) Jon Anderson 2001-01-16 08:01:50 UTC [CAD_CAM_EDM_DRO] Re: YAK (digitizer YAK at that) Carlos Guillermo 2001-01-16 10:00:45 UTC RE: [CAD_CAM_EDM_DRO] digitizer design and FAB PhilC 2001-01-16 10:28:52 UTC Re: [CAD_CAM_EDM_DRO] digitizer design and FAB Sven Peter, TAD S.A. 2001-01-16 11:35:04 UTC Re: [CAD_CAM_EDM_DRO] digitizer design and FAB