Re: [CAD_CAM_EDM_DRO] DEEP POCKET MILLING

You could drill the corners, then break a bandsaw blade and put it through
one of the holes and weld it back together - saw out the pocket and break
the blade again to remove it.
Joel

----- Original Message -----
From: "Victor Cantu Jr." <victorcantujr@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, March 28, 2001 5:17 AM
Subject: [CAD_CAM_EDM_DRO] DEEP POCKET MILLING


> I WILL SOON BE HAVING TO MAKE A PART THAT IS 12 X 6 X 6.250 DEEP. THE
PART IS ALUMINUM 70-75. ANY WAYS MY QUESTION IS IT HAS ALMOST THE ENTIRE
CENTER BORED OUT, AND THE BORE GOES ALL THE WAY THROUGH. BEFORE I GET
STARTED I AM HOPING SOMEBODY WILL GIVE ME SOME ADVICE ON TOOLING AND ALSO
HOW YOU THINK YOU WOULD GO ABOUT DOING IT.
> THANKS
>
VICTOR.
>
>
> [Non-text portions of this message have been removed]
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>