RE: [CAD_CAM_EDM_DRO] Air assist on Series II knee?

That is a novel idea. It really would not require that much pressure if the
screw was attached to a larger piston underneath. The piston would also keep
air from leaking out the cylinder. From the arrangement of the parts this is
a likely scenario.

Tim
[Denver, CO]

> Hmm, is there any chance the screw itself is the cylinder, or rather
> the piston? I'm thinking probably not, as it would require an
> unreasonably high air pressure to lift a heavy knee with the cross
> section of a typical screw. It would of course leak a bit, but the
> leaks would keep chips out of the nut.
>
> Chris
>
> FAQ: http://www.ktmarketing.com/faq.html