Re: [CAD_CAM_EDM_DRO] Phase converter for CNC lathe
Posted by
Robert Bachman
on 2001-04-30 08:34:57 UTC
Scott,
Both of my cnc machines originally were wired for 3 phase. After studying the
panel for a bit I realised the cnc control ran on single phase. The 3 phase
was split to use two of the three legs as input into a stepdown transformer
which in
turn fed the control. I now feed the transformer with a seperate single phase
220 volt line and use 3 phase only to run the spindles. This requires a
little rewiring
of the panel but eliminates running "generated" 3phase into the control.
Bob
Both of my cnc machines originally were wired for 3 phase. After studying the
panel for a bit I realised the cnc control ran on single phase. The 3 phase
was split to use two of the three legs as input into a stepdown transformer
which in
turn fed the control. I now feed the transformer with a seperate single phase
220 volt line and use 3 phase only to run the spindles. This requires a
little rewiring
of the panel but eliminates running "generated" 3phase into the control.
Bob
Discussion Thread
fuddham@a...
2001-04-29 16:53:01 UTC
Phase converter for CNC lathe
dougrasmussen@c...
2001-04-29 18:36:58 UTC
Re: Phase converter for CNC lathe
Smoke
2001-04-29 22:23:52 UTC
Re: [CAD_CAM_EDM_DRO] Phase converter for CNC lathe
cnc002@a...
2001-04-30 06:28:36 UTC
Re: [CAD_CAM_EDM_DRO] Phase converter for CNC lathe
dougrasmussen@c...
2001-04-30 07:46:45 UTC
Re: Phase converter for CNC lathe
Robert Bachman
2001-04-30 08:34:57 UTC
Re: [CAD_CAM_EDM_DRO] Phase converter for CNC lathe
cnc002@a...
2001-04-30 08:58:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: Phase converter for CNC lathe
dougrasmussen@c...
2001-04-30 17:39:39 UTC
Re: Phase converter for CNC lathe
Smoke
2001-04-30 20:51:45 UTC
Re: [CAD_CAM_EDM_DRO] Re: Phase converter for CNC lathe
fuddham@a...
2001-05-01 16:48:18 UTC
Re: Phase converter for CNC lathe
cnc002@a...
2001-05-02 11:42:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: Phase converter for CNC lathe
ballendo@y...
2001-05-02 15:17:32 UTC
Re: Phase converter for CNC lathe
cnc002@a...
2001-05-04 05:44:12 UTC
Re: [CAD_CAM_EDM_DRO] Re: Phase converter for CNC lathe
fuddham@a...
2001-05-05 09:42:12 UTC
Re: Phase converter for CNC lathe
Jon Anderson
2001-05-05 09:58:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: Phase converter for CNC lathe
Jon Elson
2001-05-06 00:43:22 UTC
Re: [CAD_CAM_EDM_DRO] Re: Phase converter for CNC lathe