Re: [CAD_CAM_EDM_DRO] Making bellows

Doug,

I like the idea of rubber. Do you know where we can get some uncured
rubber? Doesn't it need pressure as well as heat to cure? I'm sure we
could just do a search, but maybe your client could supply us with a little
info.

Thanks,

Tom Eldredge

----- Original Message -----
From: Doug Harrison <prototype@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, May 03, 2001 5:54 PM
Subject: Re: [CAD_CAM_EDM_DRO] Making bellows


> Was snooping around the drafting room during lunch and found a catalog
from
> Ain Plastics. They have a castable polyurethane that might work. It's
> about $31 a pound though. You could use a polyester or nylon fabric for
the
> base and impregnate it with this stuff.
>
> Another client of ours uses uncured rubber to make floor mats. Its soft
> until they cook it and I suppose you could hold it in a form while baking.
> Wife unit might not approve of using the kitchen oven but you could do it
> while she's shopping.
>
> Doug
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>